How do I pair my Geo Energy Monitor?
With the cover now off, turn the unit around until you see a small recessed button connected to the circuit board. Hold this button down until you see red LED light. When you release the pair button the LED flashes as the transmitter pairs with the display unit. Your display should now read “Paired”.
How do I reconnect my geo smart meter?
Unplug it from the mains and hold down the power button on the back for five seconds. Wait one minute, reconnect to power and switch it on.
How do I connect my smart meter to display?
Press and hold the power button on the back of your smart meter display to turn it on. To turn it off, press and hold the same button for five seconds. Each time you turn the smart meter display on, it will show ‘Welcome to IHD2’ then ‘Attempting to pair’.
Why is my geo smart meter not connecting?
You can reset your in-home display if you have connection issues, or if it stops updating. Unplug it from the mains and hold down the power button on the back for five seconds. Wait one minute, reconnect to power and switch it on.
Why is my smart meter not showing electric?
No Electricity or Gas After Smart Meter Installation If your electric smart meter is on but the display is blank, try to restart it by pressing B on the keyboard. If the display stays off, there might be a power cut in the area.
Why won’t my smart meter monitor connect?
If your smart energy monitor stops working check your power cable is inserted correctly and your power supply is switched on at the wall. If it’s still not working, try using fresh batteries. If batteries fix the issue, then the problem is with the cable.
How do I reconnect my smart meter display?
To restore the lost connection to your smart meter, you’ll need to:
- Take your In-Home Display to where your electricity meter is located.
- Once you’re close to the meter, hold down the “OK button” until the In-Home Display turns off and then on again.
- You should then see the message: “your smart meter is now paired”.
How do I reboot my smart meter?
To reset it it turn it right off by holding down the power button for 10 seconds and then power it back on again, it should work.