What causes an RV furnace not to ignite?
If it’s an electric furnace, then possible reasons for ignition failure includes the battery power not being sufficient or the fuse in the furnace being blown. When a propane or gas furnace isn’t igniting, the problem can be that you don’t have enough propane supply or your gas valve is not opening.
Why Is My RV furnace clicking but not turning on?
Most likely, your furnace is making a clicking noise and not providing heat because your furnace’s spark igniter is trying to ignite your pilot light or burners but is failing to do so. In other words, there’s an ignition system malfunction that needs to be fixed. Otherwise, your furnace won’t start.
Is there a reset button on a RV furnace?
Locate the reset button on the furnace and press it to reset the furnace. It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.
Why is my furnace not igniting?
If your furnace won’t ignite, the source of the issue may be a broken flame sensor. The sensor is responsible for turning off the gas burners to avoid gas buildup. Once this component starts to malfunction, it may stop the burners from igniting altogether.
How do you reset an RV furnace?
The reset button is located inside the blower compartment on the side of the motor. It is usually labeled, and sometimes red. Turn off the power supply and the gas to your furnace. If the reset button is up, push it to reset your furnace.
Why does my furnace in my RV make a clicking sound?
Furnace Clicking, But Heat Is Working Normally – Bearings Loud clicking sounds can be heard when inducer blowers and fan shafts are clogged by buildup or when bearings are worn out. Bearings on the main blower motor might click as the furnace runs because the shaft is rusted or dirty.
How do I reset my RV furnace?
The lockout condition can be reset by turning the thermostat off and reducing the temperature to a value which would not cause the furnace to turn on. Wait approximately 30 seconds and then turn the thermostat back on and increase the temperature to the desired level.
How long does it take for an Atwood 8531 IV DCLP to purge?
When I start my Atwood 8531 IV DCLP furnace it will purge, ignite and stay lit for about 6 seconds and then go out. This cycle will repeat 3 times and then just blow cold air.
Is there a part for the Atwood 8531-iv-DCLP gas valve?
There is a part, the 31150 Furnace Hydro Flame Side Outlet Gas Valve, that is said to be compatible with the 8531-IV-DCLP valve and it costs $80 at one outlet. It is supposed to be compatible with several gas valves Atwood makes. Those gas valves are 8516-IV, 8520-IV, 8525-IV, 8531-IV, and 8535-IV.
How many Atwood 8531 manuals are there in database?
Database contains 2 Atwood 8531 Manuals (available for free online viewing or downloading in PDF): Technical lnstallation manual, Technical installation manual .
How much does it cost to replace an 8531-iv-DCLP valve?
You may have to contact Atwood directly or one of its authorized dealers to find that part and get the price for it. There is a part, the 31150 Furnace Hydro Flame Side Outlet Gas Valve, that is said to be compatible with the 8531-IV-DCLP valve and it costs $80 at one outlet.